Impossible Card | Stamping Bella Tutorial

Hi all! Today I'm sharing how to make an Impossible Card featuring Sloth on a Branch

and the Encouragement sentiment set

Supplies:

Sloth on a Branch rubber stamp

Encouragement sentiment set

Card

Paper

Scoring board and bone folder

Pencil, eraser, and ruler

Embellishments

How to:

Stamp Sloth on a Branch onto white card and colour using your preferred medium. 

Cut white card to the measurements below. 

Take the 4" x 2.5" piece of card and lay it centered over the image. Make a line all around the outline. 

Cut the image inside the pen/cil line so that it is smaller, then adhere to the 4" x 25" piece of card. 

Take the 5" x 7" piece of card and mark top and bottom (on the 5") at 2.5". Draw a line from one to the other. 

On one side of the 7", make a pencil mark at 1.5" from each end and draw a line down to the intersecting line. On the opposite side, mark at 3.5" and draw a line up to the intersecting line. 

Cut on the 1.5" lines and the 3.5" up to the intersection. Then score on the 2.5" line between the 1.5" cuts. 

Flip one half of the card over. 

Take the 4-3/8" x 3-3/8" and mark in at 1-3/8 and down at 2-2/8". Cut as shown

Cut 2 pieces of paper measuring 4.75" x 3.25" and repeating the steps above, mark in from the left at 1.25" and down on the right hand side at 2.25".

Adhere the paper to the card layers, and then adhere to the card base. 

Take the image and apply foam tape to the back. Adhere to the centre panel of the base. 

Stamp the sentiment as shown onto the 5/8" x 4-3/8" piece of white card and mat with some contrasting paper. 

Apply foam tape to each end of the sentiment and adhere across the gap in front of the image. 

Embellish using die cuts and glitter dots. 

For more inspiration check out the Stamping Bella Sisterhood page over on Facebook, where you can add your own Stamping Bella creations.

My Social Media Sites